عنوان رویداد:
بیست و دومین کنفرانس شیمی معدنی ایران
برگزار شده توسط:دانشگاه کردستان
تاریخ برگزاری : 01 شهريور 1402
عنوان مقاله:
Fabrication of Novel WO3 /NiCo2O4 magnetic photocatalysts with UV-light driven photocatalytic activity in MB degradation in an aqueous solution
نویسندگان:
نرجس پورعابد، نسیم رحمتی، علی محمد خواه
دانلود فایلThis work presents the preparation and characterization of a novel synthesized Tungsten trioxide and Nickel Cobaltite hybrid (WO3/NiCo2O4) and investigates its photocatalytic activity for Methylene Blue (MB) decomposition under UV radiation. The nanopowder of WO3/NiCo2O4 was synthesized by hydrothermal method. The samples using various mass ratios (1:1, 1:2, and 2:1) of WO3 and NiCo2O4 were prepared under the same conditions. Several techniques, such as XRD, SEM, TEM, BET, DRS, and VSM were used to characterize the structure and morphology of the products. The WO3/NiCo2O4 photocatalysts exhibit enhanced photocatalytic removal efficiency towards the target pollutant in comparison to pristine NiCo2O4 and WO3. Although The valence band potential (EVB) of WO3 reaches approximately 2.7–3.4 eV which is a suitable potential for oxidation but single component WO3 has displayed low photocatalytic performance despite UV light or visible light range because of its low conduction band edge position (+0.5 V vs. NHE at pH = 0) [1]. NiCo2O4 is used as a valuable candidate for photocatalysis as it provides a redox couple of Co3+/Co2+ and Ni3+/Ni2+ which provide considerably more catalytic active sites when compared with NiO and Co3O4. However, the practical use of NiCo2O4 as photocatalytic material is minimal due to its low efficiency and long-term stability [2]. The aim of the synthesis of WO3/NiCo2O4 hybrid samples is to improve the photocatalytic properties of semiconductors and to solve the challenges that were discussed. The advantage of the above research is the use of this photocatalyst to increase the efficiency of wastewater treatment and lower the costs to remove colored pollutants. The synthesized material must have magnetic properties to reuse the synthesized sample for multiple cycles in the photocatalytic process.The magnetic separation of WO3/NiCo2O4 nanocomposite dispersed in an aqueous solution by employing a permanent magnet to provide a magnetic field is possible [3].
Dye, Nanocomposite, NiCo2O4, Photocatalyst, WO3
برای لینکدهی به این مقاله از آدرس زیر استفاده نمایید:
برای ارجاع در منابع از عبارت زیر استفاده کنید:
پورعابد، نرجس، رحمتی، نسیم، محمد خواه، علی، 1402، Fabrication of Novel WO3 /NiCo2O4 magnetic photocatalysts with UV-light driven photocatalytic activity in MB degradation in an aqueous solution، بیست و دومین کنفرانس شیمی معدنی ایران، https://conference.uok.ac.ir/fa/archive_index.php?c=HN-iicc22&aid=1517801
دیگر مقالات این رویداد:
- Synthesis of Pt-Cu alloy nanoparticles on sulfur-modified graphene as electrocatalysts for methanol oxidation reaction
هانیه لطفی، رزگار احمدی، عبدالله سلیمی
- Evaluation of photocatalytic performance based on nanomaterials as an effective advanced oxidation process (AOPs) in oil pollution treatment
فاطمه عجم، فرهاد قادری
- Effect of microwave-assistant intercalation on photoluminescence emissions and photo-stability
کامیلا نجاتی
- Synthesis, X-ray crystallography, and Hirshfeld surface analysis of a New Carbacylamidophosphate
مریم پاس، نیلوفر درستی، Harald Krautscheid
- Introduction of a new member of bipyridine-based molten salt containing copper as an efficient and reusable catalyst for the synthesis of isoxazole derivatives
زهرا شمشادی
- Efficient photoactivity of Ag/CeCoO3 toward the conversion of MB dye under the irradiation of light source
فرشاد معرفتیان، مهدیه قبادی فرد، سجاد محبی
تماس با ما
ایران، سنندج، بلوار پاسداران، دانشگاه کردستان، معاونت پژوهش و نوآوری
کدپستی: 15175-66177
تلفن: 33624008-087
پست الکترونیک: conference@uok.ac.ir
© کلیه حقوق متعلق به دانشگاه کردستان میباشد. (همایش نگار نسخه 11.0.1 )